Digikeijs DR4024 Servo Controller
The DR4024 Servo Decoder Starter Set has everything you need to setup 4 servos. Each output also has an extra switching output to switch a light or uncoupling track. Every output can also be calibrated with software which makes fitting servos a lot easier because they are set up after installation. The DR4024 decoder is the first servo decoder to work on the basis of function mapping. The decoder sees the ‘switching addresses’ as control functions for the various outputs. Depending on the mapping that has been set up, the decoder can use from 1 to 8 ‘switching addresses’.
Features:
4 servo outputs
4 switching outputs
Power indicator
Activity indicator
Mass simulation (eg semaphores, crossing gates)
Servo calibration via the control unit
Detailed mapping function
Multiprotocol (DCC/MM)
Fully CS2-compatible
POM (Programming on Main)
Separate power and signal input
Works with JMRI
Technical Features:
Power consumption: 15mA
Maximum servo load: 500mA per servo output (2 Amps total)
Maximum switching load: 1 Amp per output (3 Amps total)
