Description
The Kato N Gauge Unitrack Turntable uses special fitted 10" track sections which can serve as powered parking tracks or can be substituted with dead end pieces. It's a "snap" to swap around and add additional tracks!
While the turntable is necessarily elevated because of the need for internal motors and other below-track equipment, thanks to clever engineering it is a mere 12mm (just under half an inch) from the base of the turntable to the top of the rails. By using the flexibility of Kato Unijoiners it is possible to connect the Turntable to a tabletop layout without the need to sink the turntable into foam.
Swapping or adding tracks is as easy as removing a screw - the modular design of the Unitrack Turntable is specifically tailored to allow modelers to easily change their Turntable layout without the need for any additional wiring or soldering - simply pop the screw cover off, unscrew the single screw holding the plate in place, and either exchange it for a blank section or one with tracks. The Turntable's indexing and power routing design will take care of the rest!
Due to USPS size restrictions, we are not able to ship this set via USPS First-Class Mail International.
217mm Overall Diameter
The Central rotary bridge is 6.3" (160mm) in length, able to support most standard length locomotives up to and including the N scale SD90/43MAC
A complete 360 degree rotation takes approximately 60 seconds.
The Turntable will index in 10" sections, smoothly and quickly aligning with connected tracks automatically.
The Turntable bridge itself acts as a rotating track feeder, allowing the turntable to operate simply as a power routing system without any complex wiring or insulating blocks.
The Turntable is fully compatible with DCC systems, routing power from either your analog or DCC power pack through the included Turntable Controller.
You can download a full PDF copy of the instruction guide included with the N Gauge Kato Turntable by clicking this link: Download (9 MB).
